The Me 100 generates hydrogen by reforming methanol and water in a membrane reactor, a unique type of reactor that purifies the hydrogen as it is generated. Plug the Me100 into a standard 120 V outlet to power the pump, heater and controller, fill with 1.75:1 (by volume) methanol : water and turn on. 

The pump compresses the methanol-water mixture and pumps it through the boiler into the reactor. There, it is converted to hydrogen and other gases. The membrane extracts the hydrogen as it is produced. Waste gas and liquids exit the system separately. The methanol-water feed rate can be adjusted at the pump. The hydrogen delivery pressure and flow rate adjusts itself to follow a fuel cell load almost instantaneously, while hydrogen purity is maintained throughout. Allows fuel cell operation in dead-end mode (no bleed). 

Technical Information:-500 scc/min of 99.99995% pure hydrogen from a 1:1.25 mix of methanol and waterEnough H2 to feed a 20-50W fuel cell continuously

-Adjust the H2 pressure and flow rate by varying the methanol-water inputHydrogen delivery to 40 psi, follows load

-Waste gas delivered separately---can be analyzed or burned for heatMake 99.99995% pure hydrogen from a 1:1 mix of methanol and water. Up to 1.2 slpm H2 ouput, enough to generate 100 W in a standard PEM FC. 

-Adjust the H2 pressure and flow rate by varying the methanol-water input. Hydrogen delivery to 40 psi, follows load. Waste gas delivered separately.