PEM Fuel Cell Test Stack

NUV10 is a high powered LabView based potentiostat with three internal temperature controllers.

TEK-AP-301

Parallel evaluation of 25 MEA candidates in an array fuel cell at both low and high fuel or oxidant stoic ratios.

Gas Control units (GCU) are equipped with humidifiers, pressure gauges, flow meters and thermometers - all with digital indication.

Stand alone two channel Bubble Type Humidification System for electrochemical testing.

HSA plus two extra temperature controllers

PS-Reformate consists of a PC controlled, electronic load bank and a gas distribution unit for simulating reformate gas. Includes 6 independent gas channels; 4 fuel and 2 for oxidants, with independent control of each line.

A low cost manual test station which includes a gas management unit and an electronic load with voltage and current displays. Incorporates independent gas flow control of reactant mixtures, cell temperature control, and dynamic load control.

A HSA-TC with two heated Gas Transfer Lines

ElectroChem’s CompuCell gas management unit enables fuel cell and electrochemical testing for PEM, alkaline, and phosphoric acid fuel cells, providing capacity for single cells and fuel cell stacks.

PS-Dual Range consists of a PC controlled, electronic load bank and a dual flow rate gas distribution unit that has 4 independent gas channels; 2 fuel and 2 for oxidants, with independent control of each line.

PS-ULTIMA automated test system for qualifying up to 5 cells simultaneously. System consist of a PC controlled, electronic load bank and fuel cell system controller, operating on ElectroChem's proprietary Windows™-based software system.

Adds Direct Methanol capabilites to the Power Station test system. Includes methanol pump with flow rates from 2.6 up to 100mL/min (higher rates available on request), 1 liter stainless steel methanol reservoir, computer/local control capability.